labels are to be considered an integral part of
31. Warning: Read the instructions before op-
32. Warning:
-
33. Danger!
34. Danger! Machine rollover: Do not use this
35. Danger! Dismemberment:
36. Danger of cutting yourself: Cutting
near or under the opening of the cutting
2.4 REGULATIONS FOR TOWING
-
the instructions provided.
41.
NOTE The images corresponding to the texts
in chapters 3 et seq., can be found on pages iii et
seq. of this manual.
3. UNPACKING AND ASSEMBLY
-
-
IMPORTANT The machine is supplied without
engine oil or fuel. Before starting up the engine,
fill with oil and fuel following the instructions given
in the engine manual.
WARNING! Unpacking and completing
the assembly should be done on a flat and
stable surface, with enough space for mov-
ing the machine and its packaging, always
making use of suitable equipment.
3.1 UNPACKING
-
-
-
-
-
NOTE To avoid damaging the cutting-means
assembly when getting the machine down from
the pallet, take it to the maximum height and be
very careful.
Hydrostatic transmission:
-
engage lever should be put in position «B»
-
3.2 MOUNTING THE REAR PLATE
(Fig. 3.1)
correct right and left positions.
-
Hydrostatic transmission
To Next Page
Loading...
Need help?
General
