SV200 R200
4/2007© by GLOBAL GARDEN PRODUCTS
14 Pass one end of the cable (4) (Ø 4.5 mm - length
2.40 m) through the ventilation grille into the
hole in the pulley (3) and make a knot so that it
cannot escape.
15 Insert the other end of the rope (2) into the grip
(3) and fasten it with a knot.
16 Turn the pulley (3) and the rope (4) anticlockwise
for 6 complete turns in order to load the spring,
then release the pulley carefully to wind the
entire rope onto the pulley.
17 Check that the pulley (1) rotates freely.
18 After pulling the entire length of the rope, check
that the pulley (3) is able to complete another 2-
3 turns before compressing the spring.
19 Remount the starting system [
6.2.A].
C) Replacing the hooks
21 Remove the starting system [ 6.2.A
].
22 Loosen the central screw (6) and dismount the
bushing (7) and hooks (8) without letting the pul-
ley (3) slip out of place.
NOTE
The screw (6) has a left-handed thread and
therefore should be
unscrewed clockwise.
NOTE
Always replace the hooks (8), the bushing (7)
and the screw (6) in one block.
23 Mount the new hooks (8), taking care to position
them correctly with the bushing (7) and the
guides in the pulley hub (3). Tighten the screw
(6)
anticlockwise so that the pulley rotates
smoothly.
24 Remount the starting system [
6.2.A].
Tightening torques
3
Starting system fixing nuts ................... 5-6 Nm
6 Starter screw ......................................... 4-6 Nm
Technical information
Starter rope dimensions ..................... Ø 4.5 - 2.4m
6.2.1
STARTING SYSTEM
2 / 2
SERVICE MANUAL
page
from
2007 to ••••
8
8
4
7
7
8
3
6
8
6
8
8
3
To Next Page
Loading...
Need help?
General
