SV200 R200
4/2007© by GLOBAL GARDEN PRODUCTS
6.8 EXHAUST SYSTEM
GENERAL INFORMATION
The exhaust system consists of a muffler installed
on the cylinder together with a gasket, a spacer and
a heatproof baffle.
A malfunctioning exhaust system may lead to a loss
in power or excess noise. However, the muffler is a
preassembled part which cannot and must not be
disassembled or repaired but only replaced.
SERVICING PROCEDURES
A) Removing and replacing the muffler
1 Remove the two nuts (1) that fix the guard (2 or
2a) and the muffler (3).
2Take out the muffler (3) and the heatproof baffle
(4).
3 On assembly:
– thoroughly clean the cylinder contact surface,
removing all deposits or fragments on the
heatproof baffle;
– always replace damaged mufflers;
– always replace the heatproof baffle (4) if it is
broken or cracked;
– tighten the two nuts (1) to the specified levels.
Tightening torques
1
Muffler nuts ......................................... 8-10 Nm
6.8.1
EXHAUST SYSTEM
1 / 1
SERVICE MANUAL
page
from
2007 to ••••
3
4
To Next Page
Loading...
Need help?
General
