SV200 R200
4/2007© by GLOBAL GARDEN PRODUCTS
6.2 STARTING SYSTEM
GENERAL INFORMATION
The starting system consists of a cable wound onto
a pulley and consists of a rope wound onto a pulley.
The movement from the pulley to the flywheel (and
the engine shaft) is transmitted by a pair of hooks.
The rope is returned and rewound by a spiral spring.
Other than the possibility of the rope breaking, the
starting system may malfunction in the following
ways:
• the engine does not start (if not due to another
causes):
=rope too short, not providing an adequate
number of revs to the engine [
6.2.A].
• the pulley fails to couple with the flywheel,
noticeable by the rope unwinding without effort:
= damaged or broken hooks [
6.2.B
].
• the rope returns uncertainly or does not return:
=broken spring [
6.2.C
].
In all cases, remove the starting system to make the
necessary checks or repairs.
SERVICING PROCEDURES
A) Removing the starting system
1 The starting system (1) can be accessed after
removing the possible outside cowls and it is
fixed by three nuts (2).
B) Replacing the rope
11 Remove the starting system [ 6.2.A].
12 Keep hold of the pulley (3) and slowly unwind
(clockwise) the entire rope (4) to gradually
release the return spring. If the rope breaks, the
spring will be already released and you will only
have to unwind the rope.
13 Undo or cut the knot at the end of the rope or
remove the section still attached to the pulley.
6.2.1
STARTING SYSTEM
1 / 2
SERVICE MANUAL
page
from
2007 to ••••
5
4
4
1
2
2
3
4
3
To Next Page
Loading...
Need help?
General
