Instruction Manual Mitras LX7
EN 2016-12-27 12
The Mitras LX7 is equipped with an acclimation program that allows you to
easily adjust the performance and output of the light.
To ensure proper operation, the connection cables should never be
kinked, crimped, or positioned in an unsuitable way.
5.2 Connection to the Power Supply / Switching on the Mitras LX7
Connect the luminaire power cable to the power supply. Connect the power supply unit to
the power cord and connect the power connection cable with the plug to the power outlet.
DANGER
Aquarium specimens are very sensitive to sudden changes in lighting
conditions. If an adjustment (duration, intensity, color and alignment of the
lighting) is needed, please perform these changes gradually and observe
the reaction of the ecosystem in the aquarium.
DANGER
Products that are already powered should never be pulled by the cable.
This may cause malfunction or damage the connected power supply and
the Mitras LX7.
They should only be pulled by the plug connected to the power socket.
Mitras LX7 and its accessories are destroyed by moisture or excessive
humidity.
DANGER
Ensure that the mains voltage matches the voltage specified on the
identification plate located on the bottom of the device.
Connect the device only to a properly installed and grounded outlet
with a minimum rating of 10A.
Never use a different voltage supply. Incorrect polarity or voltage can
destroy the device.
To Next Page
Loading...
Need help?
General
