Instruction Manual Mitras LX7
EN 2016-12-27 7
Maintenance and cleaning for the luminaire should only be
performed when the unit is powered down. The luminaire must be
suspended from the ceiling fixture or disconnected from other
mounting kits. Make sure to unplug the power cord first.
Be careful when touching the lamp during operation. Some parts of
the lamp can get very warm.
The LEDs of the luminaire are extremely bright. Do not look directly
into the light source.
The luminaire must be regularly cleaned. To do this, it must be
switched of.
Disconnect the power plug by pulling the plug, not the cable.
Never attempt to disassemble, repair or alter the equipment by
yourself.
Do not insert sharp objects into the electrical contacts and ports.
DANGER
If the unit falls into the aquarium or has been exposed to moisture
or humidity, first turn off the power to the device via the fuse or
circuit breaker, then pull the power cord.
Never touch the power plug with wet hands.
If the contact of the plug is wet or soiled, please dry it completely or
clean it with a cloth. The mains plug must not be immersed in the
water.
DANGER
The device may not be operated if it has been damaged in any way
(e.g. damaged power cord or plug, liquids or objects have gotten into
the interior, device has been exposed to excessive moisture, the
normal operation is disturbed, or the device has been dropped).
If the plug or socket gets wet, first turn off the power to the device
via the fuse or the circuit breaker. Then pull the power cord.
If the lamp has fallen into your aquarium, first pull the mains plug
before you pull it out of the water. Under no circumstances should
the lamp be used again!
Never operate the lamps then leave it unsupervised when children,
pets or persons are nearby.
When cleaning the aquarium, pull the mains plug of the luminaire.
To Next Page
Loading...
Need help?
General
