65
ACCESSORIES
©Ghost Controls
®
2021
UNIVERSAL TUBE GATE BRACKET KIT AXTB
Mounting bracket kits that will attach a variety of devices to 1-1/2’-2” tubes including tubular gates. These
include gate opener kits, ZombieLock
®
, or any other device that needs to be attached to tubes.
WIRED VEHICLE SENSOR AXXV
The GHOST CONTROLS
®
Vehicle Sensor is the easiest way to trigger your gate to open when a vehicle
is trying to exit your property. This sensor is buried beneath the ground surface next to your driveway and
connects into your gate controller box. 55’ cable included (cannot be spliced)
WIRELESS VEHICLE SENSOR AXWV
The GHOST CONTROLS
®
Vehicle Sensor is the easiest way to trigger your gate to open when a vehicle is
trying to exit your property. This sensor is easy to install and sensor is buried beneath the ground surface next
to your driveway and takes 2 C batteries. Does not connect into the control box.
PUSH BUTTON AXPB
The standard push button will control a single or dual gate system up to 1,000’ ft away with low voltage wire.
LOCKING CLEVIS PIN AXLC
The GHOST CONTROLS
®
Locking Clevis Pin allows you to easily secure the gate operator arm to the
mounting brackets with a padlock by replacing the Clevis pin included in the gate opener kit.
100' WIRE AXLV
100' of 16 AWG low voltage, direct burial, standard wire for wiring the transformer or running the power cable
from solar panel.
PHOTO EYES AXPS
Adjustable photo eyes for your outdoor environment. We oer monitored and non-monitored versions.
PUSHTOOPEN GATE BRACKET KIT AXPO
The Push-To-Open Bracket is required for any gate opener system that is installed when the installation causes
the gates to swing out from the property. Most gates are installed with the swing action into the property and do
not require these brackets. Dual gates will need (2) AXPO kits.
To Next Page
Loading...
