BIOS Setup - 98 -
5-3-2-2 Memory Addressing
Parameter Description
Memory Addressing
NUMA nodes per socket
Species the number of desired NUMA nodes per socket.
Options available: Auto, NPS0, NPS1, NPS2, NPS4. Default setting is Auto.
Memory inerleaving
Enable/Disable the Memory interleaving feature.
Options available: Auto/Disabled. Default setting is Auto.
Memory interleaving size
Controls the memory interleaving size. This determines the starting address of
the interleave (bit 8, 9, 10 or 11).
Options available: Auto, 256Bytes, 512Bytes, 1KB, 2KB. Default setting is Auto.
1TB remap
Enable/Disable to remap DRAM out of the space just below the 1TB boundary.
The ability to remap depends on DRAM conguration, NPS, and interleaving
selection, and may not always be possible.
Options available: Auto, Do not remap, Attempt to remap.
Default setting is Auto.
DRAM map inversion
Enable/Disable the DRAM map inversion function.
Options available: Auto, Enabled, Disabled. Default setting is Auto.
Location of private memory
regions
Control whether or not the rpivate memory regions (PSP, SMU, and CC6) are
at the top of DRAM or distributed. Note that distributed requires memory on
all dies. Note that it will always be at the top of DRAM if some dies don't have
memory regardless of this.
Options available: Auto, Distributed, Consolidated. Default setting is Auto.
To Next Page
Loading...
Need help?
General