Appendix - 94 -
Use the Marvell Storage Utility in the Operating System:
With the Marvell Storage utility, you can set up an array or view the current array status in the operating
system. To install the utility, insert the motherboard driver disk, then go to Application Software\Install Ap-
plication Software and select Marvell Storage Utility to install. Note: After the installation, you must login
the utility with the same account name and password that you use to login the operating system. If you did
not set the account password before, click Login to enter the Marvell Storage Utility directly. Please note
that if you set the hard drive(s) to IDE or AHCI mode, it is normal that you will not see the hard drive(s) in
the Marvell Storage Utility.
To Next Page
Loading...
Need help?
General
