User Guide
GD32450Z-EVAL
40
3) udp application. Users can link the eval board with another station, using 1025 port.
Users can send information from station to board, then the board will send back the
information.
If users need dhcp function, it can be configured from the private defines in main.h. This
function is closed by default.
Note: Users should configure ip address, mask and gw of GD32450Z-EVAL-V1.1 board
or served according to the actual net situation from the private defines in main.h.
DEMO running result
Download the program <FreeRTOS_tcpudp> to the EVAL board, LED3 will light every
500ms.
Using Network assistant software, configure the pc side to tcp client, using 8000 port,
and when send something through the assistant, users can see the reply from the server:
Using Network assistant software, configure the pc side to tcp server, using 1026 port,
and when send something through the assistant, users can see the echo reply from the
client:
Using Network assistant software, configure to use udp protocol, using 1025 port, and
when send something through the assistant, users can see the echo reply from the board:
To Next Page
Loading...
