Upgrading to BRCM2.x
Page 34 MDE-5265E BRCM2.x Installation and Upgrade Instructions · April 2021
Completing Installation
To complete the installation, proceed as follows:
1 Connect the Local Area Network (LAN) cable to any available RJ-45 jack. The jack must light
up to indicate connection.
Figure 34: Connecting LAN Cable into RJ-45 Jack
Installing BRCM2.x or upgrading an existing D-Box to a BRCM2.x is now complete.
Note: For additional RJ-45 ports, an Ethernet switch might
be required. NETGEAR 5-PORT
GIGABIT ETHERNET SMART MANAGED PLUS SWITCH (GS305E) or equivalent is
recommended for use.
To Next Page
Loading...