MDE-5412C Passport® EDGE Installation and Start-up Manual · February 2019 Page 71
Passport Edge Software Setup
23 Click Update Display to display your message. If no additional changes are needed, then click
Save.
Figure 105: Updating Display
24 If displays does not auto-update the message, try stopping and restarting the MWS and each
register.
The customer display should display current date
and time, along with the message that was
programmed in, when in an idle state.
Xenon 1900 Scanner
The Passport Edge system uses the Xenon 1900 2D Scanner (PA02710513). The Xenon 1900
connects to either COM 1 or COM 2 ports on the Passport Edge Server using either a dongle or a
CAT5 cable with a Q13180-63 gender adapter. Programming of the Xenon scanner is completed
by using MDE-4956 Honeywell
®
Xenon 1900 Scanner Setup/Service Instructions with the
settings required to meet the site’s needs (age verification, QR codes, etc.) as well as those
required by the site’s backoffice provider.
Passport Report Printer
Configuration and setup of the Passport Edge Brother Report Printer is completed by
following the steps provided in the printer documentation located in the printer’s shipping
carton.
Secure Zone Router
For more information on the configuration and setup of the Passport Edge SZR, refer to
MDE-5382 Secure Zone Router (Acumera) Installation Instruc
tions.
Note: The configuration and setup must be completed at least thr
ee working days prior to the
installation of the Passport Edge into the customer’s location.
To Next Page
Loading...
Need help?
General