© 2019 Gilbarco Inc.
7300 West Friendly Avenue · Post Office Box 22087
Greensboro, North Carolina 27420
Phone (336) 547-5000 · http://www.gilbarco.com · Printed in the U.S.A.
MDE-5412C Passport® EDGE Installation and Start-up Manual · February 2019
Applause
™
Media System is a trademark of Gilbarco Inc. CRIND
®
, Gilbarco
®
, and Passport
®
are registered trademarks of Gilbarco Inc.
Cybera
®
is a registered trademark of Cybera, Inc. EMV
®
is a registered trademark of EMVCo LLC. Epson
®
is a registered trademark of Seiko
Epson Corporation. Ethernet
®
is a registered trademark of Xerox Corporation. Europay
®
and MasterCard
®
are registered trademarks of
MasterCard International Inc. GOLD
SM
is a service mark of Gilbarco Inc. Google
™
is a trademark of Google Inc. Honeywell
®
is a registered
trademark of Honeywell International Inc. Hughes
®
is a registered trademark of The DIRECTV Group, Inc. Insite360
™
is a trademark of
Gilbarco Inc. Internet Explorer
®
is a registered trademark of Microsoft Corporation. VeriFone
®
is a registered trademarks of VeriFone Inc.
Veeder-Root
®
is a registered trademark of Veeder-Root Company. Visa
®
is a registered trademark of Visa Inc. Xenon
™
is a trademark of
Honeywell International Inc.
Appendix F: Converting Site from a Non-Gilbarco POS to a Passport Edge POS
Appendix F: Converting Site from a Non-Gilbarco POS to a
Passport Edge POS
To convert from a non-Gilbarco POS, proceed as follows:
• Work with the site owner/manager to understand what data on the current POS they need
to convert or program into the Passport EDGE.
• Work with the site owner/manager to understand the disposition of the current equipment,
once it is removed.
• 24 hours prior to installation, contact the network (if required) to ensure if a new merchant
number is issued.
• If required, ensure that the correct network communication device (Datanode, Cybera
®
,
Hughes
®
, etc.) is ordered or is handy.
• Ensure that the correct D-Box for the dispensers onsite is ordered or is handy.
• Ensure that all firmware/software needed to convert the dispensers from four-wire to
two-wire is ordered or is handy.
• Ensure that all needed cabling, gender adapters and other items are on hand.
• Ensure that, if there is a tank gauge present, the correct DIMM card, gender adapter, and
cabling is ordered or is on hand.
• Ensure that all network reports, store/shift reports and all other needed reports are printed
out prior to moving onto the next step in the conversion process.
• Contact the network, to confirm if the site is correctly closed and is ready for changing to
a new PDL and that this location is “flagged” for that new PDL download.
• This should also be the time when, if the site is ready, the EMV profile should be added to
a Passport Edge POS.
To Previous Page
Loading...
Need help?
General