MDE-5412C Passport® EDGE Installation and Start-up Manual · February 2019 Page 85
Appendix E: Moving a Snapshot Backup from the PX52/PX60 System
Appendix E: Moving a Snapshot Backup from the
PX52/PX60 System
A current Snapshot must be taken on the PX52/PX60 Passport system and moved to an
external drive prior to shutting down these systems and installing the PS65 hardware.
This Snapshot will be converted and used by the PS65 system as part of the data restore
process.
IMPORTANT INFORMATION
Before beginning the snapshot process(s), ensure the following:
1 Using Figure 120, check the feature bundles that are currently turned on in the Passport
system. If there are bundles that are currently turned ON that will not be available when the
Passport Edge is installed, those MUST be discussed with the manager/owner prior to the
conversion.
Figure 120: Activated Feature Bundles
2
In Network Setting, either take pictures or note all the network settings that are currently in
use.
Note: This is extremely important as these setting ARE NOT transfered over via the snapshot
process.
To Next Page
Loading...
Need help?
General