Page 74 MDE-5412C Passport® EDGE Installation and Start-up Manual · February 2019
Appendix A: Epson TM-M30 Programming
Appendix A: Epson TM-M30 Programming
To complete the configuration and setup of the Passport Edge Receipt Printer, proceed as
follows:
Configuration of the receipt printer(s) requires IP’s schema to be setup as a part of that
process. For more information to complete this part of the configuration, refer to the IP
Schema information in step 5.
IMPORTANT INFORMATION
Note: Before beginning the configuration, ensure that you have administrator right on the
laptop/PC that you will be using.
1 Ensure that the Epson Ethernet printer is plugged into the laptop PC using a standard CAT5
cable.
2 Power up the printer once connected to the Laptop and in a minutes the following IP will
appear (see Figure 106).
Note: This is an example of the IP printout. Details may vary.
Figure 106: Printing the IP Address
The default IP address settings are listed in the following table:
Main IP Address Subnet Mask Default Gateway
192.168.192.168 255.255.255.0 0.0.0.0
To Next Page
Loading...
Need help?
General