MDE-5412C Passport® EDGE Installation and Start-up Manual · February 2019 Page 73
Passport Edge Installation
For more information on converting a site that currently has competitive POS hardware, refer to
Figure “Appendix F: Converting Site from a Non-Gilbarco POS to a Passport Edge POS” on page 96.
For more information on converting a site that currently has PX52/PX60 hardware, refer to
“Appendix E: Moving a Snapshot Backup from the PX52/PX60 System” on page 85.
Obtain the new IP addresses for each of the devices, that were on the DMZ port of the RV042 and provide
that information to the Gilbarco Agent during the registration process for communication.
Install the Passport Edge equipment in the location(s) that were agreed on during the site survey.
Confirm IP addresses for the different Gilbarco LAN Devices [Applause, Impulse, CRINDS, Back Room
Communication Module (BRCM), BRCM2, etc.] are set to the IP Addresses needed for communication to
the SZR.
Contact contact Acumera at 1-512-687-7401 or Gilbarco at 1-800-743-7501 > Press option 3 > Press
option 2) to register all the equipments connected to the SZR and any required IP Addresses for third-party
providers.
For more information on InSite360
™
, refer to steps in “Appendix C” in MDE-7171 Insite360 Passport
Configuration and Troubleshooting Manual for Passport V10 and Later.
For more information, refer to steps in “Appendix B” in MDE-5157 Gilbarco Deployment Service (GDS)
Start-up and Service Manual.
Notify that the IT/Owner is aware if the perimeter firewall device is ever changed or updated that Gilbarco
(1-800-800-7498) must be contacted prior to the change.
Note: If Gilbarco is not inform of this change or update, the site will encounter partial network communication lost or functionality.
Prior to the SZR, devices used the DMZ connection to connect to the RV042. In the SZR
architecture, the STATIC IP assigned to certain third-party devices must be reassigned
to the subnet which is assigned from the merchant network (BOS device, security
camera, IP printer, etc.). Only Impulse and Applause Servers will remain on the
10.5.60.x subnet. Further, third-party devices with Dual Network Interface Card (NIC)
connectivity should be evaluated during survey to determine if the second NIC is
required or, if connectivity to the POS and outbound from the device may be facilitated
by the Acumera MG.
IMPORTANT INFORMATION
To Next Page
Loading...
Need help?
General