MDE-5412C Passport® EDGE Installation and Start-up Manual · February 2019 Page 83
Appendix C: Registering the Store with Insite360
2 Select the Enable Insite360 check box.
3 Enter the Gilbarco ID and Customer ID values received from the corporate customer.
4 Complete the remaining configuration fields noted above based on the customer’s corporate
guidelines.
5 Select the Register Store key. The MWS message bar provides success or failure messages. If
registration is successful, the name of Register Site key changes to Unregistered Site.
6 If registration is unsuccessful, refer to the “Troubleshooting” section in MDE-5171 Insite360
Passport Configuration and Troubleshooting Manual for Passport V10 and Later.
7 If the registration is successful, select Save to save the configuration to the Passport database
and exit from Insite360 interface.
8 To verify if Insite360 has registered the store successfully, contact the Gilbarco Help Desk at
1-800-800-7498.
Field Definition
Apply to ALL register groups Apply the inside receipt header and footer configuration to all register groups
configured on Passport.
Apply only to this register group Apply the inside receipt header and footer configuration to this register group
only. Select the register group from the drop-down menu.
To Next Page
Loading...
Need help?
General