Name: Gilera Stalker 50
Brand: Gilera
Rating: 5 (1 reviews)

To Next Page

To Previous Page

03_19

03_20

Idleadjustment (03_19, 03_20)

To adjust idle speed it is necessary to reach the set screw located in the carburettor.

To carry out this adjustment it is necessary to reach the catalytic muffler as shown in

the picture, or else by lifting the saddle and removing the hatch located at the bottom

of the helmet compartment.

Turn the set screw for clearance adjustment of the throttle control transmission, then

replace the rubber protection cap. Adjust idle speed with the rear wheel off the ground

(vehicle on stand) and with a warm engine. turn the knob-type head screw in or out

until the engine idles smoothly (around 1800/2000rpm.), i.e. without the rear wheel

being moved by the engine.

CAUTION

WHEN ADJUSTING IDLE SPEED, PAY SPECIAL ATTENTION NOT TO TOUCH

THE CATALYTIC MUFFLER TO AVOID BURNS.

SHOULD THERE BE PROBLEMS DURING THE IDLE SPEED ADJUSTMENT OP-

ERATION, IT MAY BE NECESSARY TO ADJUST THE LEVEL OF EXHAUST

EMISSIONS (CO). THIS OPERATION MUST BE CARRIED OUT AT AN AUTHOR-

ISED PIAGGIO-GILERA SERVICE CENTRE.

3 Maintenance

Other manuals for Gilera Stalker 50

Questions and Answers:

Need help?

Do you have a question about the Gilera Stalker 50 and is the answer not in the manual?

General