To Next Page

To Previous Page

Care and maintenance

For glucose measurement it is necessary a particular cleaning

procedure only if blood or other material (debris, dust, etc.)

come into direct contact with the plastic support of the reader. If

so, use only a wet cloth, moistened by water or alcohol solution

of 70%, to clean the external parts of the instrument.

Since for cholesterol or triglycerides measurement the

instrument uses an optical measuring method, its components

must be kept clean. To clean the optical components, lift the

front cover and use a wet cloth on the glass surface of the

optics. After the cleaning, dry the plastic support of the reader,

without scratching it.

For taking measurements on different people, like in a hospital

for example, clean the instrument after every measurement

with a solution 70% alcohol before proceeding with the next

measurement.

Note

If the instrument is too cold or too hot (ex. after being in a car at very

low or high temperatures), allow it to cool down or to heat up slowly

at room temperature (about 20 minutes).

Preservation and measuring conditions

To assure the accuracy of each measurement, it is important to meet some

conditions.

The measurement with multiCare-in strips has to be performed between 10

and 40 °C (50-104°F). The multiCare- in kit (meter and strips) has not to be

stored at temperature lower than 5°C(41°F) and over 30°C(86°F).

Manuale MCIN UK_ED2013 APRILE MFAP Definitivo.indd 16 13/06/2013 16:52:39

Gima multiCare-in User Manual

Questions and Answers: