Start-up and installation
11
11.2020/V 2.3
The connection test is thus complete; the device is now available for programming the spe-
cific project. For programming, use the latest HS Expert setup from https://download.gira.de
2.3.1 Connection test is not successful
If the Gira HomeServer is not visible in Windows Explorer, try to address the device via the
browser.
To do this, use the information from the DHCP server of your network router to determine
the assigned IP address.
If the device is not listed there, use the IP address of the delivery status: https://192.168.0.11
(the net mask is 255.255.0.0).
If the device is equipped with an older firmware, use the IP address of the delivery state:
http://192.168.0.11/hs (the net mask is 255.0.0.0).
If the device is not accessible/visible, check your network settings.
If there are still uncertainties regarding the IP address of the Gira HomeServer, a monitor and
keyboard can be connected to the Gira HomeServer. The monitor shows, among other
things, the set IP address with the net mask. The keyboard is only required to activate the
screen.
2.4 Installation of the “HS Expert” start-up program
1. Download the current “HS Expert” version from http://download.gira.de to your PC.
2. Unpack the ZIP file.
3. Perform the setup.
4. A selection menu is created in the Windows start menu under “Gira / HS+FS Expert”.
All information and programs for the Gira HomeServer can be accessed via this menu.
To Next Page
Loading...
