Start-up and installation
9
11.2020/V 2.3
2.2 Setup and installation
The Gira HomeServer may only be set up inside buildings. It is not intended and not
approved for mobile operation.
Set up the Gira HomeServer at a central location so that connection to the mains voltage, to
the network and the KNX is trouble-free. The location should also be ‘out of the way’ so that
the device does not impede other work being carried out and so that one of its connections
cannot be accidentally interrupted.
2.2.1 Connecting to the mains voltage
The Gira HomeServer is connected via the mains cable to the mains voltage (230 V~).
i
Note: selecting the setup location.
Select a setup location where you can be sure that other work will not cause the power sup-
ply, network connection or KNX connection to be accidentally interrupted.
i
Note: sufficient air circulation.
In order to ensure perfect operation of the Gira HomeServer, a setup location should be cho-
sen that has sufficient air circulation around the device, enabling operation at room temper-
ature.
Important: the device starts up immediately when connected to the mains voltage!
The Gira HomeServer starts as soon as it is connected to the mains voltage and the On/Off
button on the rear is switched on.
The Gira HomeServer is ready for operation after the three double signal tones have
sounded.
Important: carry out lightning protection!
In order to avoid damage to the device, we highly recommend protecting the device from
overvoltage in the mains cable, at the network connection, at the ISDN adapter and in the
KNX voltage access using appropriate protective devices.
To Next Page
Loading...
