MOTION SENSOR (Battery)
1.
The Motion Sensor will come from the factory pre-programmed and pre-
installed. No additional installation is necessary.
MOTION SENSOR (Hard wired)
1. The Motion Sensor will come from the factory pre-programmed and pre-
installed.
2.
A hole must be drilled for the power wire. Locate the wire at the back of the
awning cassette and the nearest source of 12VDC power.
3.
Drill the appropriate sized hole, feed the wire to the interior of the vehicle and
connect to the 12VDC source of power.
PICTURE HERE
FIGURE 7
TESTING AND ADJUSTMENTS
OVERVIEW
To Next Page
Loading...
