(Figure 11)
TROUBLESHOOTING GUIDE
Girard Systems recommends that all adjustments be made by authorized service
centers. The following guide is intended to help you become familiar with the
awning in case of emergency.
PROBLEM:
The lead rail is binding on the side of the awning casing; i.e. the rail is offset from
housing.
SOLUTION:
Open the awning about 3 feet. Loosen the set screw on each arm at the point of
connection to the lead rail. Locate and remove the two fabric set screws that are on each
end of the lead rail. The lead rail is now ready to be shifted. Close the awning until the
lead rail is about 4” away from closing into the housing. Using a rubber mallet, tap the
end of the lead rail to move it into the correct position. When proper alignment has been
achieved retighten the lead rail set screws, then replace the fabric screws.(Figure 12)
PICTURE HERE
Figure 12
To Next Page
Loading...
