Globalsat TR-206 - Page 50

50
motion mode to on-line mode
when TR-206 does not detect
motion
1=enable
R9
Minimum distance to be
judged as moving state
u16,
Unit: meter
0 ~ 65535
RB
Keep GPRS on-line in static
state
1/0
0=disable
1=enable
RC
Keep GPRS on-line in moving
state
1/0
0=disable
1=enable
RD
Interval for switching from
validation to static state
if no motion detected
u16, in
seconds
0=Interval is the
same with R1
RE
Traveled distance to be judged
as keep in moving state
u16,
Unit: meter
RF
Interval for switching from
moving to static state
if no motion detected
u16, in
seconds
0=Interval is the
same with R1
RG
Check GPS off time setting
(C7, C8, C9, CA)
1/0
0=disable
1=enable
RH
GPS always on in moving
state
1/0
0=disable
1=enable
RI
Report Media for switching
from static state to moving
Media type
Please refer to 2.9
Report media
RJ
Report Media for switching
from moving state to static
Media type
Please refer to 2.9
Report media
Commands format:
GSC,IMEI,M4*Checksum!
Commands Codeword
Parameters
M4
Set motion mode
Example:
Set TR-206 motion mode with report interval of 3600 seconds for static state (R0),
report interval of 30 for moving state (R1) and report media (R2) TCP
GSC,130158974523157,M4(R0=3600,R1=30,R2=02)*44!