Page 8
Operating Instructions
SHARP KNIFE BLADE
TO AVOID SERIOUS PERSONAL INJURY:
• NEVER touch this slicer without training and authorization from your supervisor or if you are under 18 years
old. Read this instruction manual rst.
• NEVER TOUCH KNIFE. Keep hands and arms away from all moving parts.
• NEVER OPERATE slicer without knife cover and knife ring guard securely installed.
• BEFORE TURNING SLICER ON, place auto engage lever in “Manual” position (G12A only).
• BE ALERT. The food chute moves back and forth during automatic operation and can move in either direction
on start up (G12A only).
• NEVER put hand into the chute arm opening on the right side of the slicer.
• ONLY USE FOOD CHUTE HANDLE to push the food chute during manual slicing.
• ONLY USE THE Endweight, NOT YOUR HAND, to hold food products when slicing. Never put your hand
on or around food chute when slicer is on.
• DO NOT CATCH SLICES WITH YOUR HAND. Let slices drop onto the receiving area.
• ALWAYS turn slicer off, return auto engage lever to “Manual” position (G12A only), and turn the
slice thickness dial clockwise until it stops after each use.
• BEFORE CLEANING, SHARPENING, SERVICING OR REMOVING ANY PARTS, always turn slicer off,
turn the slice thickness dial clockwise until it stops, unplug power cord, and remove food chute.
MANUAL SLICER OPERATION
1. With the slicer turned off, pull the food chute completely towards you and place the food product onto the
food chute. When using the G12A as a manual slicer make sure to push down or lower the auto engage
lever to the “Manual” position and keep it in that position at all times. Slice only boneless, unfrozen product
with the slicer. Use the endweight to hold the food product in place.
2. Make sure all knobs are tightened prior to using the slicer.
3. Rotate the slice thickness dial counterclockwise to the desired setting. After slicing is complete, always turn
the slice thickness dial clockwise until it stops to close the slicer table.
4. Turn the slicer on by pushing the start button. The power indicator light will illuminate (see page 4 for location).
To Next Page
Loading...
Need help?
General
