Page 11
Setting Up Preset Keys
You will need to use the setup keysheet, which is permanently attached and the operating keysheet.
1. Make sure the scale is plugged in, turned on, and there is nothing on the platter.
2. Key in 9000 and press the MODE key. The display will show: P00 REGISTRATION
NOTE: If this does not appear on the display, press the RESET key to clear any data and do the step again.
3. Key in 4 and press the ENTER key twice.
4. Place the operating keysheet over the setup keysheet. Key in PLU number and press the desired preset key.
Remove the operating keysheet and make note, which preset key was used.
NOTE: Two values can be stored on each preset key. The PRINT key is used to switch between upper and
lower level. When upper level is selected, the upper level indicator will be lit.
The display will show: P04-01n01 0 0 0
5. Repeat step 4 to set up additional keys. When completed press the MODE key twice to return to normal
operation. NOTE: In normal operation use the MODE key to switch between upper and lower lever
(see page 14 step 2).
Setting Up Preset Function Keys
1. Make sure the scale is plugged in, turned on, and there is nothing on the platter.
2. Key in 9000 and press the MODE key. The display will show: P00 REGISTRATION
NOTE: If this does not appear on the display, press the RESET key to clear any data and do the step again.
3. Key in 4 and press the ENTER key twice.
4. Key in the desired preset key ag number (see list below), press the FEED key, then press the “0” zero key to
recognize the entry as the function key. NOTE: Instructions on how to use the function keys are located on
page 15. NOTE: Two values can be stored on each preset key. The PRINT key is used to switch between
upper and lower level. When upper level is selected, the upper level indicator will be lit.
The display will show: P04-01n01 0 0 0
Preset function key ag
3 Fixed Price
4 X (Multiply)
5 Special Price Discount
6 -$ Price Discount
7 -% Percentage Discount
8 Save
5. Place the operating keysheet over the setup keysheet. Press the desired preset key. Remove the operating
keysheet and make note, which preset key was used.
6. Repeat steps 4 and 5 to set up additional keys. When completed press the MODE key twice to return to
normal operation.
Preset Key Set Up
To Next Page
Loading...
Need help?
General
