Supplied By www.heating spares.co Tel. 0161 620 6677
14
221504A
SECURING
SCREW (2)
MOUNTING
PLATE
5mm
TEMPLATE
TOP BOILER
MOUNTING
HOLES
MOUNTING PLATE
FIXING POINT
5.5
ø
3
/
16
ø
PLUG
No. 10x
1
/
2
in.
5.5
ø
3
/
16
ø
PLUG
0064M
Diagram 5.4
BOILER MOUNTING and
PLATE FIXING POINTS
5 Preparation
0064M
5.4 Flue Hole Cutting
Having marked out the flue centre cut a hole for the flue using,
preferably, a 115mm minimum core drill.
Note: If required, an optional Wall Liner Kit, part No.900862, is
available, complete with fixing instructions.
5.5 Wall Mounting Bracket
Reposition the template, ensuring dimensional alignment with
the flue hole.
Mark the boiler securing screws and mounting plate position,
see diagram 5.4.
Drill holes and plug, to suit No10x50mm woodscrews, fit the
screws allowing sufficient clearance to accept the keyhole fixing
brackets.
Secure the boiler mounting plate to the wall with No.10x50
woodscrews and plugs, see diagram 5.4.
5.6 Flue Duct (Standard or Long)
Mark the duct to the length required (this length allows for
expansion), see diagram 5.5 for Rear flue and diagram 5.6 for
Side flue, then cut square and remove any burrs.
Diagram 5.5FLUE DUCT (REAR FLUE)
*Increase dimension by 15mm if the
“Optional Flue Collar” is to be fitted.
FLUE DUCT
*
Q plus 70mm
Q
6893
To Next Page
Loading...
