GME TX670 - POWERING THE RADIO; INSTALLING THE BATTERIES

POWERING THE RADIO
Your TX670 is powered by a Ni-MH rechargeable
batterypack.Ifleftunused,thebatterieswilldischarge
within a few months. If you have not used your TX670
forsometime,youwillneedtorechargeyourbattery
pack before use.
Installing the Batteries
Battery installation is easier when the belt clip is
removed.Todothis,releasethespringclipandslide
the belt clip downward and away from the radio body.
1. Press the centre-top area of the battery cover and
slide downwards.
2. Install the rechargeable battery pack in the direction
indicated on the pack until it ‘clicks’ into place.
3. Replace the battery cover and belt clip.
Belt
Clip
Spring Clip
Battery
Cover
This side
faces up
PAGE 10 INSTRUCTION MANUAL TX670