1 0991 497 EN - 24.03.2017
3010 ¾” VALVE MANUAL
INSTALLATION, USE AND MAINTENANCE
needs to be in conformity with the rules applicable in the country in which the installation operates;
if no rules exist, the qualification can be ensured by a certified EN ISO 9001 quality system
supplemented if necessary to take into account the specific features of the installation.secondo le
EN ISO 9001.
0.6 LIABILITY AND WARRANTY
These instructions are intended for people with experience in installation, adjustment and maintenance of
hydraulic lifts.
GMV disclaims any liability for damage caused by improper or different use from what described in these
instructions or inexperience or carelessness of those responsible to assemble, adjust or repair hydraulic
components.
GMV's warranty is voided if you install any components or parts not original, if you make unauthorized changes
or modifications or made by unauthorized or unqualified personnel.
Unless otherwise indicated, the following situations are forbidden for safety reasons:
- Any product modification;
The installation of the product for purposes other than those described;
Damage to the joints;
Carrying out maintenance or inspections improper or inadequate;
The use of improper accessories and not original spare parts or materials from GMV.
0.7 WARNINGS BEFORE THE INSTALLATION
In these instructions the major points concerning the safety and prevention will be marked with the following
symbols:
Warning high risk of danger. Risk of injury (e.g., crushing, sharp edges, protrusions, etc..).
Warning risk of electrical damage (exposed parts).
Beyond the instruction manual, it should take into account national standards, laws, regulations and other rules
on accident prevention and environmental protection, and special operating conditions, such as the use of the
lift, tools and equipment working.
The installation and repair technicians are primarily responsible for their own safety.
This "Manual" applies to the entire life of the facility, during normal operation, testing and maintenance to be an
integral part of the system, so it should be kept in a safe place by the installer.
The installation, commissioning and maintenance of the system may only be performed by trained personnel.
Before starting the installation work:
Use safety devices to protect personnel and prevent falls;
Cover (safely) openings in walls and floor;
Use the tools and means preventing accidental falls;
The gaps should be closed, use appropriate warning signs.
Work on electrical equipment must be performed by an electrician or other qualified personnel.
0.8 CLEANING AND POLLUTION PROTECTION
Impurities and dirty inside the equipment may cause malfunction of the hydraulic system and premature wear.
All disassembled items for inspection or repair, as well as pipes and accessories should be thoroughly cleaned
before re-assembled.
To Next Page
Loading...
Need help?
General
