EasyManuals Logo

Go! Go! Elite Traveller Plus User Manual

Go! Go! Elite Traveller Plus
40 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #22 background imageLoading...
Page #22 background image
22
IV. BATTERIES AND CHARGING
Your Travel Scooter requires two long-lasting, 12-volt, deep-cycle batteries that are sealed and mainte-
nance free. They are recharged by the supplied off-board charging system.
Charge your Travel Scooter’s batteries for 8 to 14 hours prior to using it for the first time.
Keep the batteries fully charged to keep your Travel Scooter running smoothly.
Figure 13. Battery Condition Meter
READING YOUR BATTERY VOLTAGE
The battery condition meter on the tiller console indicates the approx-
imate strength of your batteries using a color code. From right to left
on the meter, green indicates fully charged batteries, yellow a draining
charge, and red indicates that an immediate recharge is necessary. See
figure 13. To ensure the highest accuracy, the battery condition meter
should be checked while operating your Travel Scooter at full speed
on a dry, level surface.
CHARGING YOUR BATTERIES
NOTE: The battery pack can be charged on or off the Travel
Scooter.
PROHIBITED! Removal of grounding prong can create electrical hazard. If necessary,
properly install an approved 3-pronged adapter to an electrical outlet having 2-pronged plug
access.
PROHIBITED! Never use an extension cord to plug in your battery charger. Plug the charger
directly into a properly wired standard electrical outlet.
PROHIBITED! Do not allow unsupervised children to play near the Travel Scooter while the
batteries are charging. Pride recommends that you do not charge the batteries while the
Travel Scooter is occupied.
MANDATORY! Read the battery charging instructions in this manual and in the manual
supplied with the battery charger before charging the batteries.
WARNING! Explosive gases may be generated while charging the batteries. Keep the Travel
Scooter and battery charger away from sources of ignition such as flames or sparks and
provide adequate ventilation when charging the batteries.
WARNING! You must recharge your Travel Scooter’s batteries with the supplied off-board
charger. Do not use an automotive-type battery charger.
WARNING! Inspect the battery charger, wiring, and connectors for damage before each use.
Contact your authorized Pride Provider if damage is found.
WARNING! Do not attempt to open the battery charger case. If the battery charger does not
appear to be working correctly, contact your authorized Pride Provider.
WARNING! If the battery charger is equipped with cooling slots, then do not attempt to
insert objects through these slots.
WARNING! If your battery charger has not been tested and approved for outdoor use, then
do not expose it to adverse or extreme weather conditions. If the battery charger is
exposed to adverse or extreme weather conditions, then it must be allowed to adjust to the
difference in environmental conditions before use indoors. Refer to the manual supplied
with the battery charger for more information.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Go! Go! Elite Traveller Plus and is the answer not in the manual?

Go! Go! Elite Traveller Plus Specifications

General IconGeneral
Maximum Speed4 mph
Overall Height36 inches
Number of Wheels4
Seat Width18 inches
Weight Capacity300 lbs
Range Per Charge14.5 miles
Overall Width21 inches
Seat Depth16 inches
Motor24V DC
Batteries2 x 12V
Warranty on Electronics2 years
Warranty on Batteries6 Months
Wheel Size9 inches
Seat Height (from ground)22.5 inches
Warranty on FrameLifetime

Related product manuals