Name: Go! Go! Elite Traveller Plus
Brand: Go! Go!
Rating: 4 (1 reviews)

To Next Page

To Previous Page

ASSEMBLY

NOTE: Before attempting assembly, tilt the rear half of the Travel Scooter slightly back on the anti-tip

wheels as show in figure 23.

1. Use the frame release lever to lift the front section as you align the frame hooks of the front section

with the lower frame tube of the rear section. See figure 23.

2. Once the frame hooks are over the lower frame tube, lower the front section completely. This will

engage the frame lock-up.

3. Raise the tiller and fully tighten the tiller adjustment knob.

4. Reinstall the battery pack.

5. Reinstall the seat and rotate it until it is secured into place.

6. Unlock the front wheel by turning the tiller lock knob 90° counterclockwise. See figure 22.

WARNING! After assembly, make absolutely certain the tiller lock knob is in the unlocked

position before riding your Travel Scooter.

VII. DISASSEMBLY AND ASSEMBLY

FRAME RELEASE LEVER

FRAME HOOK

Figure 23. Frame Release Lever

LOWER FRAME TUBE

Questions and Answers:

Need help?

Do you have a question about the Go! Go! Elite Traveller Plus and is the answer not in the manual?

Go! Go! Elite Traveller Plus Specifications

General