Godox V1ProC - Other Applications

46
4. Set the Receiver Unit
Press the wireless button to make the <RX> is displayed on the LCD panel
of the receiver unit.
5. Set the Wireless Channels of Transmitter Unit and Receiver Unit to the
Same
For example, if the transmitter unit channel is set to 01, then the receiver
unit channel needs to be 01 as well.
The parameters of receiver unit can be directly set on the transmitter unit on the
condition that channels and IDs of them are set to the same.
Note
：
TTL/M Mode Switch Function
1. Toggle the TTL/M mode toggle switch in non-wireless mode can switch
flash mode.
2. TCM switch function is workable by default when switched to M manual
mode from TTL mode.
Locking Function
Press and hold the < > button for 2s can lock or unlock the screen, “LOCKED”
is displayed on the LCD panel when the screen is locked.
The Reason & Solution of Not Triggering in Godox 2.4G
Wireless
Disturbed by the 2.4G signal in outer environment (e.g. wireless base
station, 2.4G wi router, Bluetooth, etc.)
→
To adjust the channel CH setting on the flash trigger (add 10+
channels) and use the channel which is not disturbed. Or turn off the other
2.4G equipment in working.
Please make sure that whether the flash has nished its recycle or
caught up with the continuous shooting speed or not (the flash ready
indicator is lightened) and the flash is not under the state of over-heat
protection or other abnormal situations.
→
Please downgrade the flash power output. If the flash is in TTL mode,
please try to change it to M mode (a pre-flash is needed in TTL mode).
Whether the distance between the flash trigger and the flash is too close
or not (
＜
0.5m).
→
Please turn on the “close distance wireless mode”:
X1 Series: Press and hold the triggering button then turn on the device
until the indicator blinks twice.
Xpro and X2T Series: Set the C.Fn-DIST to 0-30m.
X nano C: Set the trigger distance to 0-30m.
Whether the flash trigger and the receiver end equipment are in the low
battery states or not
→
Please replace the battery.
1.
2.
3.
4.
Sync Triggering
The sync cord jack is a Φ2.5mm plug. Insert a trigger plug here and the flash
will be red synchronously with the camera shutter.
Other Applications
Modeling Flash
If the camera has a depth-of-eld preview button, pressing it will re the flash
continuously for 1 second. This is called modeling flash. It enables you to see
the shadow effects on the subject and the lighting balance. You can re the
modeling flash during wireless or normal flash shooting.