3. Moving and Stopping
Startup and Takeoff
An additional startup sequence is needed to enter the Motor Standby Mode and be ready
for takeoff.
● Please make sure the scooter is unlocked.
● Retract the main stand and side stand, leave the electronic throttle or reverse
throttle not activated, close the seat firmly and keep the scooter in complete
standstill.
● Hold down the brake lever and press the “GO” button; you’ll see the
speedometer on the dashboard start counting down. The scooter enters motor
standby mode as “0” appears on the speedometer.
● Release the brake lever and twist the throttle to start riding.
Stopping
To slow down or stop the Smartscooter®, hold down the brake lever while moving.
● The braking light at the tail will light up when holding down the brake lever.
● The braking light will snub out when releasing the brake lever.
● During the emergency brake from high speed, all turn signals lights will flash rapidly
to remind other drivers on the road.
● Flashing signals will turn off when you release the brake lever, or when the vehicle
speeds lower down.
15
The throttle will not respond while the Smartscooter® is moving backwards
(gliding or being pushed), and the torque will be inactive until the Smartscooter®
is fully stopped to 0 km/h.
Please keep hands free from the throttle or reverse button when starting the
scooter, and please keep the stands retracted, seat closed firmly and the scooter
in complete standstill. Check above conditions if the warning symbol
displayed when you try to start Smartscooter®.
Extending the side stand when the Smartscooter® is moving at low speed (<
5km/h) will turn the motor off. Please do not extend it while on the move to avoid
the sudden power loss or unexpected danger.
To Next Page
Loading...
