6. Maintenance
Proper service and maintenance ensure durability, reliability and safety of your
Smartscooter®. It’s recommended to take care of your scooter by following the instructions
below.
Check the Following Before Your Ride
● Make sure the tire pressure is within normal range; recommended tire pressure is 33
psi for the front wheel and 40 psi for the rear (Gogoro 2 Rumbler: Front 30 psi, rear
33 psi).
● If the tire surface has any cracks, damage, excessive abrasion, object punctures or
attachments.
● If the tire treads have enough depth above 0.8mm.
● If the tension of the chain is proper, or any cleaning or lubrication is needed.
● If the suspension or powertrain is leaking or has exterior anomaly.
● The cooling air intake is clean and unobstructed.
● No warning symbol on the dashboard is lit after the scooter is unlocked.
● If the batteries still have sufficient power for your trip.
● If switches and buttons on the left and right handles are working normally.
● If the headlight, braking light and indicator lights and horn are working normally.
● Mirrors are clean and set to appropriate angles.
● If the braking fluid level is appropriate, the entire braking system is working normally.
● If the Saferide™ electronic throttle and reverse throttle are working normally.
● Other items required by local regulations.
Daily Cleaning and Maintenance
● Please keep the Gogoro Network™ Smart Battery in the seat trunk and remain trunk
closed.
● To prevent primary battery exhaustion, it is recommended to remove the primary
battery at Gogoro Service Center if you plan not to use Smartscooter® for a period
of time. Please contact Gogoro Service Center for more details.
● If possible, park your vehicle indoors in dry, shaded and cool places. This will slow
down the normal wear and tear of the scooter caused by the sun and rain.
● Please use soft cloths, sponges or soft brushes along with tap water and mild
detergent to clean the exterior.
● Avoid cleaning with a powerful water jet to prevent excessive humidity from entering
and damaging the interior.
● To extend the chain service life span and comfort, lube the chain with chain
lubricant every 500 km, after washing, riding in the rain, or riding through a water
pitㄡ
31
To Next Page
Loading...
