PROBLEM
CAUSE
SOLUTION
The GN remote control
doesn't control the DS-10
PLUS
The App can't find the DS-10
PLUS in the network
The GN remote control can be
used to control more than one
unit. To control each unit the
correct mode must be selected
on the remote.
The DS-10 PLUS is not
connected to the network.
Select DAC mode on the remote.
The button "DAC" is located in the upper part
of the remote.
See page 10 for more information.
Make sure the DS-10 PLUS is connected to
the WLAN or LAN either with the Ethernet
cable or the Wi-Fi.
See page 20 for more information.
Make sure the RF antenna is correctly
installed. It may be impossible to use the DS-
10 PLUS with the Wi-Fi if the RF antenna is not
installed.
When using Wi-Fi, make sure the DS-10 PLUS
is connected to the correct WLAN. Don't
forget to put in the password to complete the
connection if required by your network setup.
If you have any questions contact us at:
service@goldnote.it
For spare parts visit the official Gold Note store at:
www.akamaiaudio.it
24
TROUBLESHOOTING
To Next Page
Loading...
