golmar 7W/G2+ - Communication Screen Functions

12
ART 7W/G2+ MONITOR
Communication screen
This screen is displayed during a communication process. In the top centre of the screen, the date and time are
shown and, on the right, the source of the image is displayed.
End audio communication with the door panel displayed and then show the main menu.
07-04-2020 Door panel 111:17:10
1
2
Access the image and communication settings menu.
Start or end audio communication with the door panel displayed. Communication
has a maximum duration of 90 seconds. Once communication has ended, the screen will
turn off.
Change the source of the image as long as the system has more than one door panel or has an
external camera connected and display has been activated (see p. ). It is possible to make the
change during display, call and communication processes.
28
If you have a MicroSD card inserted, it starts recording a 15-second video within a few seconds of
receiving the call. Otherwise, it will take a photograph. In the top left of the screen, icon is
displayed and indicator will illuminate.
By pressing, it records a video. (See p. to set the recording mode).9
1
2
A few seconds after receiving a call, it automatically takes a photograph. In the top left of the screen,
icon is displayed and indicator will illuminate.
By pressing, it takes a photograph. (See p. to set the recording mode).9
Important: New settings menu with ART 7W G2+ monitor with V.04 and later.
ART MONITOR7W/G2+
Activate the lock release (or device connected to the relay output of the door panel) for 3 seconds
(factory setting, programmable by the installer; see ). During activation, indicator will illuminate.
2
p.28
Activate the lock release (or device connected to the relay output of the door panel) for 3 seconds
(factory setting, programmable by the installer; see ). During activation, indicator will illuminate.
1
p.28