Commander III
2-44
013G+
Confirm Restore
Warning: This operation will replace the
existing system configuration with
data values from the current backup.
Do you wish to continue?
OK = Continue ESC = Cancel
013G+
Restore Controller Memory: If adjustments have
been made to the controller that are not desired,
press the number 8 button to restore the system to the
settings that were stored in the computer memory the
last time the Backup Controller Memory button (#7)
was pressed. A Conrm Restore screen will appear.
Press the OK button to continue with the restoration.
All settings will revert to what was last saved. Press
the ESC button to retain the current adjustments.
Main Menu
About display
220-0016
087G+
Curb & Gutter - G+
Copyright ©2010-2012 GOMACO Corporation
GCURB1
GCURB2
GSLAV3
GSLAV3
GSLAV3
GCURBD
V1.07
V1.10
V1.10
V1.05
V1.05
V1.05
About
?
087G+
Shows the software loaded into the display and
the controllers with the software version number.
Press the escape button (ESC) to return to the main
menu. The numbers in this display will change if the
controllers are reprogrammed. Note the numbers
before discussing diagnostic procedures with
GOMACO personnel.
Main Menu
Help display
220-0017
020G+
Menu Navigation
?
- Use the arrows to move the selection cursor
over the desired menu item. Press the OK button
to open the selected screen.
- Menu items with hotkeys have a numeric value (1-8)
displayed in the lower left corner. Press the desired
number key to open that screen.
- Press the ESC key to exit the current screen
and return to the previous screen.
020G+
From the main menu display, press the navigation
buttons to move the red selection cursor to the Help
menu icon (#7). Press the OK button to enter the
active Help display screen (or press the number 7
button to bypass cursor navigation and directly enter
the Help display screen). Press the escape button
(ESC) to return to the Main menu.
The Help display screen explains the G+ display and
menu navigation and how to enter data values. Press
the right arrow button (►) to move forward through
the help displays or press the left arrow button (◄)
to move backwards through the help displays. Press
the escape button (ESC) to return to the main menu.
Press the OK button when a question mark (?) is
viewed in the upper right corner of any display to view
a help display screen.
08–Moving the Machine
Before starting the engine, all oil and coolant levels
should be checked. The machine should be greased
as specied in the maintenance chapter. Position all
FNR switches in the neutral (N) position. Be certain all
variable control dials are in the off position. Be certain
all emergency stop buttons are reset.
Notice: Do not use starting uid (ether) when
cranking the engine as it may cause damage to the
engine.
Turn the ignition switch to the “on” position for 10 to 15
seconds, or until the “Wait To Start Preheat” message
is not indicated on the engine display in cold start
conditions. This will allow the engine pre-heater to
warm the intake air prior to cranking the engine. Turn
To Next Page
Loading...