5. To reduce the risk of any sharp edges inside
the hull tracks cutting the tramp, use a small
piece of rod wrapped in sand paper (120 grit
or less) and slide the length of the track and
back to sand the inside edge of it.
6. The tramp should be pre-fitted to the front beam at the factory. If not remove the end plate from the
front beam and slide the trampoline into the front beam groove refitting the end plate once the
tramp is in place.
7. Loosen all beam bolts 2 turns; fully remove the beam bolts from one end of the front beam and
allow the bows to move closer together.
8. Insert the bolt ropes on either side into the
track of the hull. Carefully slide the
trampoline down the track on each hull. This
is best done with 1 person on either side of
the platform keeping it even on each side. It
is recommended you have someone feed the
tramp into the track while another person
pulls the tramp on.
To Next Page
Loading...