Goodwe DNS G3 Series User Manual

System Commissioning
32
User Manual V1.0-2022-03-22
8.2.2 Inverter Parameter Introduction
Parameters Description
Normal Home page. Indicates the real-time power of the inverter.
2022-02-14
09:01:10
Check the time of the country/region.
VPv1 Check the DC input voltage of the inverter.
IPv1 Check the DC input current of the inverter.
Vac Check the voltage of the utility grid.
Iac Check the AC output current of the inverter.
Fac Check the frequency of the utility grid.
E-Today Check the generated power of the system for that day.
E-Total Check the total generated power of the system.
Serial Number Check the serial number of the inverter.
GW5000-DNS-30
RSSI
Check the signal strength of the communication module.
Firmware M/S Check the rmware version.
Comm Version Check the ARM software version.
Set Safety
Set the safety country/region in compliance with the local grid
standards and application scenario of the inverter.
Set Date
Set time according to the actual time in the country/region where the
inverter is located.
Set Time
Set Password
The password can be changed. Keep the changed password in mind
after changing it. Contact the after-sales service if you forget the
password.
W/L Reset Power o and restart the communication module.
W/L Reload
Restore the factory settings of the communication module.
Recongure the communication module network parameters after
restoring the factory settings,
PF Adjust Set the power factor of the inverter according to the actual situation.
SetModbusAddr Set the actual Modbus address.
Set ISO
Indicates the PV-PE insulation resistance threshold value. When the
detected value is under the set value, the IOS fault occurs.

Goodwe DNS G3 Series Specifications

General

Brand	Goodwe
Model	DNS G3 Series
Category	Inverter
Language	English