OTHERS OTHERS
27
28
TECHNICAL PARAMETERS OF EH INVERTER
4.3 TECHNICAL PARAMETERS AND CERTIFICATES
Technical Data GW6000-EH GW5000-EH GW3600-EH
Max. Charging/Discharging Current (A)
Max. Charging/Discharging Power (W) 6000 5000 3600
Battery Ready Optional Function YES YES YES
Max. DC Input Power (W) 8000 6650 4800
Max. DC Input Voltage (V) 580 580 580
MPPT Range (V) 100~550 100~550 100~550
*6
MPPT Range for Full Load (V) 250~550 210~550 150~550
Nominal DC Input Voltage (V) 380 380 380
No. of Strings per MPP Tracker
Nominal Apparent Power Output to Utility
Grid (VA)
*2
Max. Apparent Power Output to Utility
Grid(VA)
*2
*1
*1
*1
Max. Apparent Power from Utility Grid (VA)
12000(Charging
6kw,backup output 6kw)
10000(Charging
5kw,backup output 5kw)
7200(Charging
3.6kw,backup output 3.6kw)
Nominal Output Voltage (V)
Nominal Output Freqency (Hz)
Max. AC Current Output to Utility Grid (A)
*2
*1
*1
*1
Max. AC Current From Utility Grid (A) 52.2 43.4 32
Output THDi (@Nominal Output)
Max. Output Apparent Power (VA) 6000 5000 3600
Peak Output Apparent Power (VA) 7200,60sec 6000,60sec 4320,60sec
Max. Output Current (A) 26.1 21.7 15.7
Automatic Switch Time (ms)
Nominal Output Voltage (V)
Nominal Output Frequency (Hz)
Output THDv (@Linear Load)
Back-up Output Data (Back-up)
AC Output/Input Data (On-grid)
Adjustable from 0.8 leading to 0.8 lagging
Battery Charged By PV Max. Efficiency
Battery Charge/discharge From/To AC Max.
Efficiency
Anti-islanding Protection
Battery Input Reverse Polarity Protection
Insulation Resistor Detection
Residual Current Monitoring Unit
Output Over Current Protection
Grid Output Short Protection
Output Over Voltage Protection
Operating Temperature Range (℃)
*3
Communication with Portal
Size (Width*Height*Depth mm)
Standby Self Consumption (W)
*4
Safety Regulation IEC/EN 62109-1&2 IEC/EN 62109-1&2 IEC/EN 62109-1&2
*2: The grid feed in power for VDE-AR-N 4105 and NRS097-2-1 is limited 4600VA, for AS/NZS 4777.2 is limited 4950VA & 21.7A.
*3: CAN communication is configured by default. If 485 communication is used, please replace the corresponding communication
line.
*4: No Back-up Output.
*5: Not all certifications & standards listed, check the official website for details.
*6: When there is no battery connected, inverter starts feeding in only if string voltage is higher than 200V.
Certifications & Standards
*5