Goodwe LX A5.0-30 - Equipment Handling; Installing the Inverter

45
Insulation gloves and
safety gloves
Dust mask
Goggles
Safety shoes
5.3 Equipment Handling
CAUTION
 Operations such as transportation, turnover, installing and so on must meet the requirements
of local laws and regulations.
 Move the equipment to the site before installation. Follow the instructions below to avoid
personal injury or equipment damage.
1. Consider the weight of the equipment before moving it. Assign enough personnel to
move the equipment to avoid personal injury.
2. Wear safety gloves to avoid personal injury.
3. Keep balance to avoid falling down when moving the equipment.
5.4 Installing the Inverter
CAUTION
 Avoid the water pipes and cables buried in the wall when drilling holes.
 Wear goggles and a dust mask to prevent the dust from being inhaled or contacting eyes
when drilling holes.
 Make sure the inverter is firmly installed in case of falling down.
Step 1: Put the mounting plate on the wall horizontally and mark positions for drilling holes.
Step 2: Drill holes with hammer drill.
Step 3: Use expansion bolts to fix the mounting plate on the wall.
Step 5: Install the inverter on the mounting plate. Tighten the nuts to secure the mounting plate
and the inverter.