Goodwe SDT G2 Series - Electrical Connection; Electrical Connection Safety Precautions

17
User Manual V1.0-2022-01-17
05 Installation
Installation Angle Requirements
• Install the inverter vertically or at a maximum back tilt of 15 degrees.
• Do not install the inverter upside down, forward tilt, back forward tilt, or horizontally.
The following tools are recommended when installing the equipment. Use other auxiliary tools on
site if necessary.
Installation Tool Requirements
Goggles Safety shoes Safety gloves Dust mask
RJ45 crimping
tool
Diagonal
pliers
Marker Level Heat shrink
tube
Rubber
hammer
DC wiring
wrench
Vacuum
cleaner
Torque wrench
Cable tieMultimeter
Wire
stripper
Hammer
drill
Heat gun
DC terminal
crimping tool
M3/M5