Gossen MetraWatt SECUTEST ST BASE - Page 80

80 Gossen Metrawatt GmbH
User Interface Icons
Icon Softkey Variants, Test Sequence
Test for Protection Class I DUTs
Exposed, conductive parts are connected to the protec-
tive conductor so that they’re not charged with voltage if
the basic insulation should fail.
Test for Protection Class II DUTs
These DUTs are equipped with double insulation or rein-
forced insulation.
Test for Protection Class III DUTs
These DUTs are supplied with safety extra-low voltage
(SELV). Beyond this, no voltages are generated which
exceed SELV.
Type B applied parts (body)
Type BF applied parts (body float)
Type CF applied parts (cardiac float)
Configure sequence parameters (see page 87)
Set classification parameters (see page 81)
Assess visual inspection or function test with OK
or not OK (toggle key)
Enter a comment, e.g. for the visual inspection or function
test
Continue test, next test step in the test sequence
End continuous measurement, next test step in the test
sequence
Accept changed parameter,
return to memory view
End test sequence
– Repeat inspection (if it has been failed).
– Repeat test step
– Skip inspection test step
– Skip individual tests in the test sequence
This option can be enabled for the user in SETUP under
“Auto Measurements”.
Start evaluation – record measured value. Each time this
softkey is pressed, an additional measured value is saved
and the number is increased by one.
Start evaluation sequence during a continuous measurement .
The number blinks.
Record measured value during the evaluation sequence of a
continuous measurement .
Repeat measured value recording
Delete measured value
Display measured values
Display details from the results list
Hide details from the results list
The ID number to which the measurement(s) will be stored
can be entered here.
Valid measured values have been obtained for a test
sequence. This measurement can be saved.
Save measurement data as (with display of directory path
/ test object ID or new entry of a test object ID other than
the preselected one)
Transmit measurement data to a PC, e.g. in order to save
them to IZYTRONIQ software (push-print function) –
refer to IZYTRONIQ online help for description
Read-out of a complete test report at the end of a test
sequence
Read-out of a summarized test report at the end of a test
sequence
Read-out of all failed test steps instead of a test report at
the end of the test sequence
Icon Softkey Variants, Test Sequence