9
locating, Location reports will include the GPS coordinates of the last known positions as well as
a LAC code, Entering the LAC code to the “Manual Track” menu of web tracking platform
www.gpstrackerxy.com will enable you to see the tracker’s current location. You can also send
command “address+password” to the tracker to request exact address, track will automatically
switch to tracking by LBS in GPRS mode. Accuracy of LBS depends on the distance to the
nearest GSM Network Cell Tower or Base Station.
Note: This feature can be used normally in most areas according to the signal of GSM network. It
may not be available in some areas.
5.13 Monitor
5.13.1 The command to switch between Track mode and Monitor mode are “tracker” and
“monitor”.The default mode is “track” (Track mode).
5.13.2 Send SMS “monitor+password” to the unit, and it will reply “monitor ok!” and switch to
“monitor” mode.
5.13.3 Send SMS “tracker+password” to the unit, and it will reply “track ok!” and switch to “track”
mode.
5.14 Data logging
5.15.5 Auto logging：When the tracker device lost GSM signals or fall offline from GPRS, tracker will
log the tracking position and alerts automatically in the SD card on the basis of the pre-set
condition, when GSM signals get back, all the event alerts will be auto-sent to the authorized
numbers or web platform (server), but the logged tracking data should be loaded to the web
platform via SMS command.
5.15.6 Logging upon times: Send SMS: “save030s005n+password” to the tracker unit, it will reply
“save ok”, and will log the Latitude and longitude locations every 30 seconds for 5 times. (S:
second, m: minute; h: hour).
5.15.7 Multi-logging：Send SMS:”save030s***n+password” to tracker device, it will reply “save ok”.
5.15.8 Cancel logging: Send SMS “nosave+password”, e.g. nosave123456
5.15.9 Logging Clearance: send SMS: “clear+password” to tracker device, it will reply “clear ok”.
5.15.10 Logging Volume: It depends on the capacity of the SD card inserted in the tracker device.
5.15.11 The logged data in SD card can be copied to computers through card reader, and then the data
route can be checked by importing data in the menu “Data Import” of web platform
www.gpstrackerxy.com
5.15 Data Load
5.15.1 Current date Load: Send SMS: “load+ password” to tracker device, it will reply: “load ok” if the
device is working well under GPRS mode; if not, it will reply “load fail! Please check gprs” that
To Next Page
Loading...
