5
5.1 SIM card installation
Make sure that there is no call transfer and call display is on, and PIN code off. The SMS
message must in Text format, can’t be identified for PDU format.
5.1.1. Open the rear cover, and pick out the battery.
5.1.2. Push the foil up according the arrow on the foil and load the miscro SD card and
push back.
5.1.3. Put the SIM card into the holder as picture shows.
5.2 Battery and Charger
Do charge the battery to capacity in 8 -12 hours for first time. Please use the battery and
charger provided by the manufacturer. This unit adopts built-in Li-ion battery, and full
battery can standby 80 hours. After first use, the battery usually should be charged in 3-5
hours.
a: For it’s Li-ion battery, which contains harmful chemicals and may burst, please don’t
bump, puncture it violently and keep it off fire.
b: Please charge the battery in time to keep it working normally.
5.3 Startup
Put the SIM card and battery in place.
Turn on the unit outdoors by pressing the “on/off” button until the indicator is on.
For first use, please initialize the unit and restore it to default setting. (Please refer to
section 5.4 for instruction.)
In 10 or 40 seconds, the unit will begin to work and acquire the GSM signals as well as
the GPS signals. The indicator will keep flashing every 3 seconds when the unit has
received the signals.
To Next Page
Loading...
Need help?
General
