12
Example: Send "area123456 22.353648,113.543678 school,800M".
Note: 5 areas at most and the distance between two points can't be less than the total distance in the
2 commands, and different areas can't cover each other.
5.19.5.2 Delete areas
Send SMS command:"noarea+password+space+area name", tracker will reply:"noarea ok".
5.19.5.3 Rename and set distance
Send SMS command "rename+password+space+old name;new name,distanceM" to tracker, if
name is not repeated and area doesn't cover others, it will reply "rename ok!" for successful
configuration.
Example: Send"rename123456 area01;school,800M", it means the new area name is "school", and
covers area of a radius of 800 meters.
5.19.5.4 Activate multi-area management
Send SMS command "area+password+space+on" to tracker, it will reply "Area
on ok!", when tracker enter the pre set area, it will send SMS "area
name+latitude & longitude" to all the authorized phone number, and send same
SMS when goes out of the area.
5.19.5.5 Deactivate Multi-area management
Send SMS command "area+password+space+off" to tracker, it will reply"area off ok!"
5.19.6 Movement alert
5.19.6.1 Set up: when the unit stays immobile in a place for 3-10 minutes with GPS signal reception,
the user can send SMS“move+password+space+0200” to the tracker (Suppose area of a radius of
200 meters, it supports 4 digits at most. Unit: Meter). It will reply “move OK”. In case of such a
movement (the default distance is 200m), it will send SMS “Move+latitude & longitude” to the
authorized numbers.
5.19.6.2 Cancel: Send SMS “nomove+password” to deactivate the movement alarm.
5.19.7 Overspeed alert
5.19.7.1 Set up: Send SMS: “speed+password+space+080” to the unit (suppose the speed is
80km/h), and it will reply “speed ok!”. When the target moves exceeding 80 km/h, the unit will
send SMS: “speed+080!+Geo-info” to the authorized numbers, overspeed alert will send only
one time in 3 minutes in SMS mode.
5.19.7.2 Cancel: Send SMS “nospeed+password” to deactivate the overspeed alert.
Remark: The recommended speed should be not less than 50km/h. For below that rate, it will be
effected the accuracy by gps signals drift etc.
5.19.8 Built in Acceleration Sensor Alarm
The tracker is built in 3-axis acceleration sensor; the tracker can detect it when the vehicle moves,
tilt or shock.
To Next Page
Loading...
Need help?
General
