At the switching on the flame isn’t started immediately, depends from the selected functioning
formality. Two formalities are settable: AUTOMATIC or MANUAL, for further details see the
appropriate section.
The switching on Stage, which has the duration of about 15-20 minutes, are necessary to the
resistence to carry the pellets at the switching on temperature, (depends from the heater). The
switching on procedure is showed from a passages set showed in the display. Before starting the
switching on, the heater performs the brazier cleaning and displays the following wording:
Firstly,
Secondly,
Thirdly,
The starting first phase is showed from the message ‘FEED’. In this phase are performed the
chimney verification operations and the pellets will be loaded in the melting pot. The successive
phase will be showed from the inscription ―Lighting”. In this phase there will be the appearance of
the first breeding grounds. This state remains up to when the smokes temperature doesn‘t exceed
the planned threshold.
!! ATTENTION !!
From the appearance of the first breeding grounds, some minutes can spend before the end of the
switching on phase.
To Next Page
Loading...
