When the switching on phase is finished, some minutes will spend necessary for the flame
stabilization. This phase is showed from the message ‘STABILIZATION” which finishes
after some minutes going up at the work phase
When the switching on phases are finished the heater will show the own state on the
display..
It is possible to switch off the heater in every functioning phase, except that during the
programming. The switching off performs pressing the key ON/OFF for two seconds, as
previously described.
!! ATTENTION !!
If the heater is switched off, the flame will continue to be present up to the fuel
exhaustion contained in the melting pot, this phase will manage in automatic
way both fans and it will have the duration up to 5 minutes.
The switching off phase is displayed from the message ‗SWITCHING OFF” present up to
the end of the operation.
Whether the heater is switched or not, on the display will display the hour, the power, and
the planned set temperature.
To Next Page
Loading...
