Common Procedures
3A4476E 23
Flush a New Sprayer
Always start with a fully charged battery.
Refer to battery and charger information
provided.
This sprayer arrives from the factory with a
small amount of test material in the system.
It
is important that you flush this material
from the sprayer before using it for the first
time.
See
Cleaning Fluid Compatibility
,
page 26 and
Static Grounding Instructions
(Oil-Based materials)
, page 26 for additional
information when using oil-based materials.
1. Remove cup assembly from the sprayer
by turning and pulling down.
2. Unscrew cup cover from the cup support.
3. Make certain FlexLiner is in the cup
support.
4. Fill FlexLiner with cleaning fluid.
See
Cleaning Fluid Compatibility, page 26
.
To Next Page
Loading...
