Graco 190ES - Setup

Control Board Replacement
18 312805A
Installation
1. Push grommet and power cord wires into strain
relief in control board (18).
2. Connect power cord connectors to terminals indi-
cated on control board (18).
3. Slide control board into place on side of motor front
endbell.
4. Replace three screws (11). Torque to 30-35 in-lb
(3.4-3.9 N.m).
5. Connect motor connector (D) and pressure control
assembly connector (A).
6. Install shroud (12) with screw (13). Install front cover
(32) with two screws (11). (see illustration, page 14).
7. Install the following on 210
ES Hi-Boy models:
a. Install toolbox (3) with two screws (5).
b. Install kick stand (66).
Route power cord (19) between coupled hose (42)
to filter manifold and sprayer frame.
ti6122a
18
Grommet
Strain
Relief
C
120V
240V
A
D18
18
D
A
ti6143b
C
Bottom View of Sprayer
ti11555a
42
19
ti11553a
11
C
120V
240V
A
D18
18
D
A
ti6143b
C